افران تنشيط الكربون الافقية الحديدية

Technical proposal


Steel belt activated carbon drying and reactivation furnace

PART 1, Main technical parameters:
1.1 Heating power : 120 KW, PID power is adjustable
1.2 Heating temperature : 200~700℃ (adjustable)
1.3 Heating method : heated by thermal radiation rod
1.4 Furnace body’s length : 4m
1.5 Heating steel belt’s material and width : SUS314/δ 1.2mm width : 800mm
1.6 Heating zone: 4 zones (each zone is regulated intelligently and individually)

PART 2,Equipment’s characteristics:
This equipment makes the dry activation through steel belt transfers and radition heating . And it is mainly used in powder and granular materials’ drying in these fields : metallurgy , chemical industry , food industry and so on..
2.1 The dying effect is good . The drying has a penetrability , it can thoroughly dry both inside and outside materials with high effeciency.
2.2 These parts that would touch the materials are all made up of stainless steel , hence no material pollution.
2.3 Reliable operation and high degree of automation . Due to the use of steel belt transfers , which has advantages of smooth movement , no vibration ,low noise and automatic materials’ in and out , it reduces labor costs greatly.
2.4 Energy saving . Owing to the use of drying technology and steel belt transfers , the production efficiency will be higher and the materials’ losses will be reduced greatly.

PART 3,Structure’s characteristics:
The equipment is divided into 4 parts : furnace body, steel belt transfers system , heating system and temperature control system.
3.1 Heating of the furnace body :
Dimension (approx.) 7500 × 1500 × 1600 (mm), it uses the heat radiation rods as the heating elements . On the top of the furnace body ,there are four open intakes helping removing the water steam during drying.

3.2 Steel belt transfers system:
The furnace body is equipped with two large steel belt driving wheels . One is in the front of furnace and the other is on the back . And one is the driver wheel with heavy corrective device which can make the steel belt keep tension condition.

3.3 Control System:
To make the equipment’s heating be more uniform and controllable , the heating furnace body is divided into four zones.
Control method: The Japanese SHIMADEN regulator , PID output , SCR (controls silicon) control temperature

PART 4, Quotation :
4.1 Electric heating method : USD 70,000 FOB Changsha China per one set
4.2 Gas-fired heating method : USD 98,000 FOB Changsha China per one set

------------------------------------------------------------------------------
COMPONENTES OF HOREZINTAL REACTIVATION CARBON FURNACES(KLIN
1， Driving wheel
2， Feeding equipment
3， Feeding stage
4， Feeding shelf
5， Loading section
6， Pipe-line
7， Driving system
8， Driving wheel
9， Drawing mechanism
10， Steel belt
---------------------------------------------------------------------------------
About your questions, our engineer replied as follows :
1,Our equipment is a horizontal type , activated carbon dewatering,drying and reactivation furnace.
2,This equipment adopts a continuous fluidized-bed type working-method . The activated carbon are tiled on the furnace's transport steel-belt.
3,The heating method can be gas-fired or electric-fired. You can choose the one you preferred.
4,Our equipment is a more advanced carbon reactivation furnace.